MasterSeal P 770 | MCTCHEMICALS | MASTER BUILDER SOLUTIONS

MasterSeal P 770 is applied as a primer for mineral substrates in MasterSeal systems. The primer improves adhesion and prevents pinholes or bubbles in the hardened topcoat.

FEATURES AND BENEFITS
Low viscosity for easy application
Excellent substrate penetration
Seals pores and capillaries
Moisture tolerant, suitable for substrates with high residual humidity
Strong adhesion to substrates
Solvent-free formulation
APPROVALS AND CERTIFICATES

CE Certification as a primer for MasterSeal M 790 in the MasterSeal 7000 CR system, in compliance with EN 1504-2.

APPLICATION METHOD

(a) Surface Preparation
Ensure substrates are structurally sound, dry, free of laitance, loose particles, oil, grease, paint stains, and other contaminants.
For concrete, prepare the surface using shot blasting, high-pressure water jetting, or other suitable methods. Concrete and cementitious substrates should have a minimum pull-off strength of 1 N/mm². Furthermore, Rough or irregular surfaces should be leveled before application with an appropriate fairing coat like MasterEmaco N 5100 FC.
Substrate temperature should range from +5ºC to +35ºC.

(b) Mixing
MasterSeal P 770 is supplied in pre-measured kits with exact mixing ratios. To begin, combine the entire contents of Part A with Part B and mix using a mechanical drill and paddle at low speed (max. 400 rpm) for 90 seconds. It is crucial to ensure thorough mixing and avoid introducing air bubbles.

(c) Application
Apply MasterSeal P 770 to the prepared surface using a brush or roller. The cure time is influenced by ambient, material, and substrate temperatures. In particular, at lower temperatures, the curing time increases, while higher temperatures accelerate the reaction. The primer forms a transparent film within 5 hours at 20°C. If necessary, apply a second coat of primer. Subsequently, allow at least 5 hours at 20°C before applying MasterSeal systems. It is recommended to overcoat within 48 hours; otherwise, consult your Master Builders Solutions representative.

FINISHING AND CLEANING
Clean tools with a solvent-based cleaner while still wet. Once cured, the material can only be removed mechanically.

COVERAGE
MasterSeal P 770 typically covers 0.20 – 0.4 kg/m², depending on substrate absorption and roughness. Conduct site trials for precise consumption rates.

WORKING TIME
Approximately 20 minutes at 20°C for both ambient and substrate temperatures.

PACKAGING
MasterSeal P 770 is available in 5 kg kits (2.2 kg Part A and 2.8 kg Part B) and 9 kg kits (4 kg Part A and 5 kg Part B).

COLOR
Milky ivory

DATA SHEET
MasterSeal P 770