Sika AnchorFix®-2+ Tropical
Sika Confirm availability
High-Performance Two-Component Anchoring Adhesive
Data sheet details on request.
Product finder
Anchor Fixing
Anchoring & fixing — Rebar, bolts and base plates into concrete. Show 4 products ↓
- Step 1 (completed)Anchoring & fixing
- LocationApplies everywhere
- ResultProducts & systems
Your products are below
For this problem the location does not change the recommendation.
How it happens
How anchors and fixings fail
What goes wrong
- A: The load pulls the anchor out of the concrete.
- B: If the hole is dusty or wet, the resin does not bond and the anchor slides out.
- C: Otherwise the concrete itself breaks out in a cone around the anchor.
- D: An anchor too close to an edge or too shallow has a smaller cone and fails at a lower load.
How it is fixed
Drill, then clean the hole thoroughly, inject a resin anchor rated for the job and respect the embedment, edge distance and curing time given by the manufacturer. A structural engineer designs anchors for loads. See the anchoring guide below.
Products for this problem
Matching products (4)
Sika AnchorFix®-2
Sika Confirm availability
Why: Sika AnchorFix®-2 may only be used by experienced professionals. As a fast curing anchoring adhesive for all grades of: Rebars / reinforcing steel, Threaded rods, Bolts and special fastening systems In the following substrates:. (TDS p.1)
- Fast curing
- Standard guns can be used
- High load capacity
- Surfaces
- concrete · masonry · mortar · steel/metal · natural stone
- System
- Rebar & Anchor Installation
Sika AnchorFix®-3+
Sika Confirm availability
Why: Sika AnchorFix®-3+ may only be used by experienced professionals. For the fixing of non-expanding anchors in the following: Structural work: Rebar / steel reinforcement anchoring in new and refurbishment works, Threaded rods, Bolts and special fastening / fixing systems. (TDS p.1)
- Long Open Time
- Can be used in damp concrete
- High load capacity
- Surfaces
- concrete · masonry · mortar · steel/metal · wood/timber
- System
- Rebar & Anchor Installation
Sika AnchorFix®-1
Sika Confirm availability
Why: As a fast curing anchoring adhesive for all grades of: Rebars / reinforcing steel, Threaded rods, Bolts and special fastening systems In the following substrates:. (TDS p.1)
- Fast curing
- Standard guns can be used
- Can be used at low temperatures
- Surfaces
- concrete · masonry · mortar · steel/metal · natural stone
- System
- Rebar & Anchor Installation
Product facts on these cards are taken from the manufacturer data sheets (page cited on each card) and are being reviewed by our technical team. Always check the data sheet before use.
Step-by-step
Follow a complete solution
Machine foundations & equipment bedding
Generators, compressors, presses, pumps and turbines need a foundation that carries vibration and impact without loosening. The usual build-up is engineered concrete, anchored or grouted holding-down bolts, and a high-strength non-shrink bedding grout.
Chemical anchors, rebar & dowels
Chemical anchors fix bolts, threaded rods and new reinforcement bars into existing concrete or masonry for extensions, railings, machines and services. Load capacity depends on the design, hole cleaning and base material, so safety-critical work needs an engineer.
Crane rail & runway grouting
Overhead and gantry crane rails in workshops, steel mills and ports sit on grouted sole plates fixed with holding-down bolts. A high-strength, non-shrink grout with good fatigue and impact resistance keeps the rail level under repeated wheel loads.
Recommended system
Complete systems that solve it
Advice
Not sure which one fits your site?
Send us the condition, the area and the surface. Your selection is already in the message.